PLANET XGS3-24040 - Manual (Page 671)

XGS3 Command Guide
39-3
Parameter: None
Default: Disabled
Command Mode: Admin Mode
Usage Guide: Enable the switch, and display PIM-DM state-refresh timer information in detail
Example:
Switch # debug ipv6 pim timer srt
Remark: Other debug switches in PIM-DM are common in PIM-SM.
39.2.3 ipv6 mroute
Command: ipv6 mroute <X:X::X:X> <X:X::X:X> <ifname> <.ifname>
no ipv6 mroute <X:X::X:X> <X:X::X:X> [<ifname> <.ifname>]
Function: To configure static multicast entry. This no command deletes some static multicast entries or
some egress interfaces.
Parameter: are the source address and group address of multicast.
<ifname> <.ifname>, the first one is ingress interface, follow is egress interface.
Command Mode: Global Mode.
Default: None.
Usage Guide: The should be valid VLAN interfaces. The multicast data flow will not be
forwarded unless PIM is configured on the egress interface and the interface is UP. If the state of the
interface is not UP, or PIM is not configured, or RPF is not valid, the multicast data flow will not be
fordwarded. To removed the specified multicast routing entry. If all the egress interfaces are specified, or
no interfaces are specified, the specified multicast routing entry will be removed. Otherwise the multicast
routing entry for the specified egress interface will be removed.
Example:
Switch(config)#ipv6 mroute 2001::1 ff1e::1 v10 v20 v30
39.2.4 ipv6 pim bsr-border
Command: ipv6 pim bsr-border
no ipv6 pim bsr-border
Function: To configure or delete PIM6 BSR-BORDER interface.
Parameter: None.
Default: Non-BSR-BORDER.
Command Mode: Interface Configuration Mode.
Usage Guide: To configure the interface as the BSR-BORDER. If configured, BSR related messages will
not receive from or sent to the specified interface. All the networks connected to the interface will be
considered as directly connected.
Example:
Switch(Config-if-Vlan1)#ipv6 pim bsr-border