PLANET XGS3-24040 - Manual (Page 684)

XGS3 Command Guide
39-16
no debug ipv6 pim timer joinprune pt
no debug ipv6 pim timer joinprune
no debug ipv6 pim timer register rst
no debug ipv6 pim timer register
no debug ipv6 pim timer
Function: Enable or Disable each PIM timer.
Parameter: None
Default: Disabled
Command Mode: Admin Mode.
Usage Guide: Enable the specified timer’s debug information.
Example:
Switch# debug ipv6 pim timer assert
39.3.10 ipv6 mroute
Command: ipv6 mroute <X:X::X:X> <X:X::X:X> <ifname> <.ifname>
no ipv6 mroute <X:X::X:X> <X:X::X:X> [<ifname> <.ifname>]
Function: To configure static multicast entry. This no command deletes some static multicast entries or
some egress interfaces.
Parameter: are the source address and group address of multicast.
<ifname> <.ifname>, the first one is ingress interface, follow is egress interface.
Command Mode: Global Mode.
Default: None.
Usage Guide: The <ifname> should be valid VLAN interfaces. The multicast data flow will not be
forwarded unless PIM is configured on the egress interface and the interface is UP. If the state of the
interface is not UP, or PIM is not configured, or RPF is not valid, the multicast data flow will not be
fordwarded. To removed the specified multicast routing entry. If all the egress interfaces are specified, or
no interfaces are specified, the specified multicast routing entry will be removed. Otherwise the multicast
routing entry for the specified egress interface will be removed.
Example:
Switch(config)#ipv6 mroute 2001::1 ff1e::1 v10 v20 v30
39.3.11 ipv6 pim accept-register
Command: ipv6 pim accept-register list cess-list-name>
no ipv6 pim accept-register
Function: Filter the specified multicast group.
Parameter: cess-list-name> is the applying access-list name
Default: Permit the multicast registers from any sources to any groups
Command Mode: Global Mode
Usage Guide: This command is used to configure the access-list filtering the PIM REGISTER packets.
The addresses of the access-list respectively indicate the filtered multicast sources and multicast groups’
information. For the source-group combinations that match DENY, PIM sends REGISTER-STOP