PLANET XGS3-24040 - Manual (Page 193)

12-59
Usage Guide:
The port locking timer function is a dynamic MAC address locking function. MAC address locking
and conversion of dynamic MAC entries to secure address entries will be performed on locking
timer timeout. The MAC address binding function must be enabled prior to running this command.
Example:
Set port1 locking timer to 30 seconds.
Switch(config)#interface Ethernet 1/1
Switch(Config-If-Ethernet1/1)# switchport port-security timeout 30
12.2.11 switchport port-security violation
Command:
switchport port-security violation {protect | shutdown}
no switchport port-security violation
Function:
Configure the port violation mode. The “no switchport port-security violation” restore the
violation mode to protect.
Command Mode:
Port mode.
Parameter:
protect refers to protect mode; shutdown refers to shutdown mode.
Default:
The port violation mode is protect by default.
Usage Guide:
The port violation mode configuration is only available after the MAC address binding function is
enabled. when the port secure MAC address exceeds the security MAC limit, if the violation mode is
protect, the port only disable the dynamic MAC address learning function; while the port will be shut
if at shutdown mode. Users can manually open the port with no shutdown command.
Example：
Set the violation mode of port 1 to shutdown.
Switch(config)#interface Ethernet 1/1
Switch(Config-If-Ethernet1/1)# switchport port-security violation shutdown