PLANET XGS3-24040 - Manual (Page 397)

29-110
Parameter:
egp means the route is learnt from the external gateway protocols, igp means the route is learnt
from the internal gateway protocols, incomplete means the route origin is uncertain.
Command Mode:
route-map mode
Usage Guide:
To use this command, one match clause should at first be defined.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set origin egp
29.26 set originator-id
Command:
set originator-id >
no set originator-id [>]
Function:
Configure the origin ip address of the BGP routing message. The “no set originator-id
[>]” command deletes the configuration.
Parameter:
> is the ip address of the route source shown by dotted decimal notation.
Command Mode:
route-map mode
Usage Guide:
To use this command, one match clause should at first be defined.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set originator-id 10.1.1.1
29.27 set tag
Command:
set tag >
no set tag [>]
Function:
Configure the tag domain of OSPF routing messages. The “no set tag [>]” command
deletes this configuration.