PLANET XGS3-24040 - Manual (Page 304)

23-17
Chapter 23 Commands for ND
Snooping
23.1 clear ipv6 nd snooping binding
Command:
clear ipv6 nd snooping binding []
Function:
Clear all dynamic binding of ND Snooping.
Parameter:
the name of an ethernet port.
Default:
None.
Command mode:
Admin Mode.
Usage Guide:
Clear all ND Snooping binding table or binding entries of a port, the entries of the corresponding
FFP hardware drive will also be cleared.
Example:
Switch(config)#ipv6 nd snooping enable
Switch# clear ipv6 nd snooping binding
23.2 debug ipv6 nd snooping
Command:
debug ipv6 nd snooping {packet | event | binding}
no debug ipv6 nd snooping {packet | event | binding}
Function:
Open/close the debug of ND Snooping.
Parameter:
packet shows debug information of received and sent ND packets, event shows debug information
that ND snooping processes the packets and the timer event, binding shows the debug information
of ND Snooping managing the binding table.
Default:
Disable the debug information.
Command mode:
Port Mode.
Usage Guide:
Open the debug information switch of ND Snooping.
Example:
Show the debug information of ND Snooping.
Switch#debug ipv6 nd snooping packet