PLANET XGS3-24040 - Manual (Page 759)

Commands for Security Function Chapter 2 Commands for 802.1x
42-31
Function: Enables periodical supplicant authentication; the “no dot1x re-authentication” command
disables this function.
Command mode: Global Mode.
Default: Periodical re-authentication is disabled by default.
Usage Guide: When periodical re-authentication for supplicant is enabled, the switch will re-authenticate
the supplicant at regular interval. This function is not recommended for common use.
Example: Enabling the periodical re-authentication for authenticated users.
Switch(config)#dot1x re-authentication
42.20 dot1x timeout quiet-period
Command: dot1x timeout quiet-period <seconds>
no dot1x timeout quiet-period
Function: Sets time to keep silent on supplicant authentication failure; the “no dot1x timeout
quiet-period” command restores the default value.
Parameters: is the silent time for the port in seconds, the valid range is 1 to 65535.
Command mode: Global Mode.
Default: The default value is 10 seconds.
Usage Guide: Default value is recommended.
Example: Setting the silent time to 120 seconds.
Switch(config)#dot1x timeout quiet-period 120
42.21 dot1x timeout re-authperiod
Command: dot1x timeout re-authperiod <seconds>
no dot1x timeout re-authperiod
Function: Sets the supplicant re-authentication interval; the “no dot1x timeout re-authperiod”
command restores the default setting.
Parameters: is the interval for re-authentication, in seconds, the valid range is 1 to 65535.
Command mode: Global Mode.
Default: The default value is 3600 seconds.
Usage Guide: dot1x re-authentication must be enabled first before supplicant re-authentication
interval can be modified. If authentication is not enabled for the switch, the supplicant re-authentication
interval set will not take effect.
Example: Setting the re-authentication time to 1200 seconds.
Switch(config)#dot1x timeout re-authperiod 1200
42.22 dot1x timeout tx-period
Command: dot1x timeout tx-period
no dot1x timeout tx-period