PLANET XGS3-24040 - Manual (Page 612)

XGS3 Command Guide
38-41
Default: The AS number isn’t initialized to 0 by default.
Usage Guide: This command set the AS number for specified Peer. The no command restores the AS
number of specified MSDP Peer.
Example:
Switch(config)#router msdp
Switch(router-msdp)#peer 20.1.1.1
Switch(router-msdp-peer)# remote-as 20
38.4.25 router msdp
Command: router msdp
no router msdp
Function: Enable the MSDP protocol of the switch, enter MSDP mode; the no form command disable
MSDP protocol.
Command Mode: Global Mode.
Default: Disabled.
Usage Guide: Enable MSDP on global mode, but even configured PIM SM at the same time, then the
MSDP can be work.
Example: Enable MSDP on global mode.
Switch(config)#router msdp
38.4.26 sa-filter
Command: sa-filter {in | out} [ list <acl-number | acl-name> | rp-list <rp-acl-number | rp-acl-name>]
no sa-filter {in | out} [ list <acl-number| acl-name> | rp-list
rp-acl-name>]
Function: To configure the filter policy of receiving or transmitting messages, which can be used to
controls the receiving and transmitting source message.
Parameter: in: To filter the SA messages from specified MSDP Peer.
out: To filter the SA messages transmitted from specified MSDP Peer.
acl-number: Specified advanced ACL number（100-199）.
acl-name: Specified advanced ACL name.
rp-acl-number: Specified standard ACL number（1-99）.
rp-acl-name: Specified standard ACL name.
If the parameter isn’t specified, all the SA messages which include (S, G) item will be filtered.
Command Mode: MSDP Configuration Mode and MSDP Peer Configuration Mode.
Default: All the SA messages receiving or transmitting will not be filtered.
Usage Guide: Configuration in the peer mode will override that in the MSDP configuration mode. The
distribution of SA messages can be controlled through this command or the redistribute command.
Example:
Switch(config)#router msdp