PLANET XGS3-24040 - Manual (Page 750)

Commands for Security Function Chapter 2 Commands for 802.1x
41-22
Default: None.
Command Mode: Admin and Configuration Mode.
Usage Guide: When no access control list is specified, all the access control lists will be displayed; in
used x time（s） is shown the times the ACL had been quoted.
Example:
Switch #show ipv6 access-lists
ipv6 access-list 500(used 1 time(s))
ipv6 access-list 500 deny any-source
ipv6 access-list 510(used 1 time(s))
ipv6 access-list 510 deny ip any any-destination
ipv6 access-list 510 deny tcp any any-destination
ipv6 access-list 520(used 1 time(s))
ipv6 access-list 520 permit ip any any-destination
41.29 show time-range
Command: show time-range
Functions: Reveal configuration information of time range functions.
Parameters: word assign name of time-range needed to be revealed.
Default: None.
Command Mode: Admin and Configuration Mode.
Usage Guide: When not assigning time-range names, all time-range will be revealed.
Examples:
Switch#show time-range
time-range timer1 (inactive, used 0 times)
absolute-periodic Saturday 0:0:0 to Sunday 23:59:59
time-range timer2 (inactive, used 0 times)
absolute-periodic Monday 0:0:0 to Friday 23:59:59
41.30 time-range
Command: [no] time-range
Functions: Create the name of time-range as time range name, enter the time-range mode at the same
time.
Parameters: time_range_name, time range name must start with letter, and the length cannot exceed
16 characters long.
Command Mode: Global mode
Default: No time-range configuration.
Usage Guide: None
Examples: Create a time-range named admin_timer.
Switch(config)#Time-range admin_timer