PLANET XGS3-24040 - Manual (Page 274)

17-32
Tunnel name
Mode
Tunnel type
Source
Tunnel source ipv4 address
Destination
Tunnel destination ipv4 address
Nexthop
Tunnel next hop (only applies to ISATAP tunnel)
17.2.37 description
Command:
description <desc>
no description
Function:
Configure the tunnel description. The no operation of this command will delete the tunnel
description.
Parameters:
<desc> is the tunnel description, which is a string no longer than 31 characters, without any spaces
or tab between characters.
Command Mode:
Tunnel Configuration Mode.
Default:
There is no tunnel description by default.
Usage Guide:
When there is more than one tunnel in the system, configuring description will help user with
identifying the purposes of different tunnels.
Examples:
Set the tunnel description as toCernet2.
Switch(Config-if-Tunnel1)#description toCernet2
17.2.38 tunnel source
Command:
tunnel source {|}