PLANET XGS3-24040 - Manual (Page 108)

XGS3 Command Guide
4-108
Chapter 4 Commands for Network Port
Configuration
4.1 Commands for Ethernet Port Configuration
4.1.1 bandwidth
Command:
bandwidth control <bandwidth> {transmit | receive | both}
no bandwidth control
Function:
Enable the bandwidth limit function on the port; the no command disables this function.
Parameter:
is the bandwidth limit, which is shown in Mbps ranging between 1-1000000K; both refers to the
bandwidth limit when the port receives and sends data, receive refers to the bandwidth limit will only performed when
the switch receives data from out side, while transmit refers to the function will be perform on sending only.
Command Mode:
Port Mode.
Default:
Bandwidth limit disabled by default.
Usage Guide:
When the bandwidth limit is enabled with a size set, the max bandwidth of the port is determined by this size other
than by 10/100/1000M. If [both | receive | transmit] keyword is not specified, the default is both.
The
bandwidth
limit can not
exceed the
physic
maximum
speed
possible on
the port. For
example, an
10/100M
Ethernet
port can not
be set to a
bandwidth
limit at
101000K (or
higher), but
applicable