PLANET XGS3-24040 - Manual (Page 131)

XGS3 Command Guide
7-131
Default:
None.
Usage Guide:
This command can only be effect only if the specified interface is disabled by ULDP.
Example:
To reset all the port which are disabled by ULDP.
Switch(config)# uldp reset
7.7 uldp recovery-time
Command:
uldp recovery-time
no uldp recovery-time
Function:
To configure the interval for ULDP recovery timer. The no form of this command will restore the default configuration.
Parameters:
recovery-time is the time out value for the ULDP recovery timer. Its value is limited between 30 and 86400 seconds.
Command Mode:
Global Configuration Mode.
Default:
0 is set by default which means the recovery is disabled.
Usage Guide:
If an interface is shutdown by ULDP, and the recovery timer times out, the interface will be reset automatically. If the
recovery timer is set to 0, the interface will not be reset.
Example:
To set the recovery timer to be 600 seconds.
Switch(config)# uldp recovery-time 600
7.8 show uldp
Command:
show uldp [interface ethernet]
Function:
To show the global ULDP configuration and status information of interface. If is specified, ULDP
configuration and status about the specified interface as well as its neighbors’ will be displayed.
Parameters:
is the interface name.
Command Mode:
Admin and Configuration Mode.
Default:
None.
Usage Guide:
If no parameters are appended, the global ULDP information will be displayed. If the interface name is specified,
information about the interface and its neighbors will be displayed along with the global information.