PLANET XGS3-24040 - Manual (Page 689)

XGS3 Command Guide
39-21
39.3.21 Command: ipv6 pim multicast-routing
no ipv6 pim multicast-routing
Function: Enable PIM-SM globally. The “no ipv6 pim multicast-routing” command disables PIM-SM
globally.
Parameter: None
Default: Disabled PIM-SM protocol
Command Mode: Global Mode
Usage Guide: Inspect the changing information about pim state by this switch..
Example: Enable PIM-SM globally.
Switch (config)#ipv6 pim multicast-routing
39.3.22 ipv6 pim neighbor-filter
Command: ipv6 pim neighbor-filter cess-list-name>
no ipv6 pim neighbor-filter cess-list-name>
Function: Configure the neighbor access-list. If filtered by the lists and connections with neighbors are
created, this connections are cut off immediately. If no connection is created, this connection can’t be
created.
Parameter: cess-list-name> is the applying access-list’ name
Default: No neighbor filter configuration
Command Mode: Interface Configuration Mode
Usage Guide: ACL’s default is DENY. If configuring access-list 1, access-list 1’s default is deny. In the
following example, if “permit any” is not configured, deny fe80:20e:cff:fe01:facc is the same as deny any.
The command can configure on IPv6 tunnel interface, but it is successful configuration to only configure
tunnel carefully.
Example: Configure vlan’s pim neighbor access-list.
Switch (Config-if-Vlan1)#ipv6 pim neighbor-filter myfilter
Switch(config)#ipv6 access-list standard myfilter
Switch(config_IPv6_Std-Nacl-myfilter)#deny fe80:20e:cff:fe01:facc
Switch(config)#ipv6 access-list standard myfilter
Switch(config_IPv6_Std-Nacl-myfilter)#permit any
39.3.23 ipv6 pim register-rate-limit
Command: ipv6 pim Register-rate-limit
no ipv6 pim Register-rate-limit