PLANET XGS3-24040 - Manual (Page 860)

62-9
62.11 show startup-config
Command: show startup-config
Function: Display the switch parameter configurations written into the Flash memory at the current
operation; those are usually also the configuration files used for the next power-up.
Default: If the configuration parameters read from the Flash are the same as the default operating
parameter, nothing will be displayed.
Command mode: Admin Mode
Usage Guide: The show running-config command differs from show startup-config in that when the
user finishes a set of configurations, show running-config displays the added-on configurations whilst
show startup-config won’t display any configurations. However, if write command is executed to save
the active configuration to the Flash memory, the displays of show running-config and show
startup-config will be the same.
62.12 show switchport interface
Command: show switchport interface [ethernet ]
Function: Show the VLAN port mode, VLAN number and Trunk port messages of the VLAN port mode
on the switch.
Parameter: is the port number.
Command mode: Admin mode
Example: Show VLAN messages of port ethernet 1/1.
Switch#show switchport interface ethernet 1/1
Ethernet1/1
Type :Universal
Mac addr num : No limit
Mode :Access
Port VID :1
Trunk allowed Vlan :ALL
Displayed Information
Description
Ethernet1/1
Corresponding interface number of the Ethernet.
Type
Current interface type.
Mac addr num
Number of interfaces with MAC address learning
ability.