PLANET XGS3-24040 - Manual (Page 121)

XGS3 Command Guide
4-121
Usage Guide:
This command is configures the port speed and duplex mode. When configuring port speed and duplex mode, the
speed and duplex mode must be the same as the setting of the remote end, i.e., if the remote device is set to
auto-negotiation, then auto-negotiation should be set at the local port. If the remote end is in forced mode, the same
should be set in the local end.
1000Gb ports are by default master when configuring nonegotiate mode. If one end is set to master mode, the
other end must be set to slave mode.
force1g-half is not supported yet.
Example:
Port 1 of SwitchA is connected to port 1 of SwitchB, the following will set both ports in forced 100Mbps at half-duplex
mode.
SwitchA(config)#interface ethernet1/1
SwitchA(Config-If-Ethernet1/1)#speed-duplex force100-half
SwitchB(config)#interface ethernet1/1
SwitchB(Config-If-Ethernet1/1)#speed-duplex force100-half