PLANET XGS3-24040 - Manual (Page 114)

XGS3 Command Guide
4-114
of 1/9 ports which belongs to the engineering department, while the name of 1/12 ports is assigned with Server,
which is because they connected to the server. In this way the port distribution state will be brought to the table.
Example:
Specify the name of 1/1-2 port as financial.
Switch(config)#interface ethernet 1/1-2
Switch(Config-If-Port-Range)#name financial
4.1.9 negotiation
Command:
negotiation {on|off}
Function:
Enables/Disables the auto-negotiation function of a 1000Base-FX port.
Parameters:
on: enables the auto-negotiation; off: disable the auto-negotiation.
Command mode:
Port configuration Mode.
Default:
Auto-negotiation is enabled by default.
Usage Guide:
This command applies to 1000Base-FX interface only. The negotiation command is not available for 1000Base-TX
or 100Base-TX interface. For combo port, this command applies to the 1000Base-FX port only but has no effect on
the 1000Base-TX port. To change the negotiation mode, speed and duplex mode of 1000Base-TX port, use
speed-duplex command instead.
Example:
Port 1 of Switch1 is connected to port 1 of Switch2, the following will disable the negotiation for both ports.
Switch1(config)#interface ethernet1/1
Switch1(Config-If-Ethernet1/1)#negotiation off
Switch2(config)#interface ethernet1/1
Switch2(Config-If-Ethernet1/1)#negotiation off
4.1.10 rate-suppression
Command:
rate-suppression {dlf | broadcast | multicast}
no rate-suppression {dlf | broadcast | multicast}
Function:
Sets the traffic limit for broadcasts, multicasts and unknown destination unicasts on all ports in the switch; the no