PLANET XGS3-24040 - Manual (Page 423)

31-136
Parameter:
|> is the IP address prefix and its length in the network.
<ifname> is the name of a interface.
Default:
Not running RIP protocol
Command Mode:
Router mode and address-family mode
Usage Guide:
Use this command to configure the network for sending or receiving RIP update packets. If the
network is not configured, all interfaces of the network will not be able to send or receive data
packets.
Example:
Switch# config terminal
Switch(config)# router rip
Switch(config-router)# network 10.0.0.0/8
Switch(config-router)# network vlan 1
Related Command:
show ip rip, clear ip rip
31.28 offset-list
Command:
offset-list <access-list-number |access-list-name> {in|out} []
no offset-list <access-list-number |access-list-name> {in|out} []
Function:
Add an offset value to the metric value of the routes learnt by RIP. The “no offset-list
<access-list-number |access-list-name> {in|out} []” command disables
this function.
Parameter:
< access-list-number |access-list-name> is the access-list or name to be applied. is
the added offset value, ranging between 0-16; is the specific interface name
Default:
Default offset value is the metric value defined by the system.
Command Mode:
Router mode and address-family mode
Example:
Switch# config terminal
Switch(config)# router rip