PLANET XGS3-24040 - Manual (Page 803)

52-1
Chapter 52 Commands for RSPAN
Configuration
52.1 remote-span
Command: remote-span
no remote-span
Function: To configure VLAN to RSPAN VLAN. The no form of this command will delete the RSPAN
VLAN.
Parameter: None.
Command Mode: VLAN Configuration Mode.
Default: Not configured.
Usage Guide: This command is used to configure the existing VLAN as RSPAN VLAN. Dedicated
RSPAN VLAN should be configured before RSPAN can function. When configuring RSPAN VLAN, it
should be made sure that specialized VLAN, such as the default VLAN, dynamic VLAN, private VLAN,
multicast VLAN, and layer 3 interface enabled VLAN, should not be configured as RSPAN VLAN. If any
existing sessions are still working when RSPAN is disabled, these sessions will be still working
regardless the configuration change. However, if any layer 3 interface is configure in the VLAN after
RSPAN is disable, the existing RSPAN session will be stopped.
Example:
Switch(Config-Vlan5)#remote-span
52.2 monitor session remote vlan
Command: monitor session <session> remote vlan <vid>
no monitor session <.session> remote vlan
Function: To configure local mirror session to RSPAN. The no form of this command will restore the
RSPAN to local mirror.
Parameter: <session>: session ID ，range between 1 to 4. <vid>: The id of RSPAN VLAN.
Command Mode: Global Mode.
Default: Not configured.
Usage Guide: To configure local mirror session to RSPAN. The VLAN id is the RSPAN VLAN. The
mirrored data grams will be attached with RSPAN tags.
Example:
Switch(config)#monitor session 1 remote vlan 5
52.3 monitor session reflector-port
Command: monitor session <session> reflector-port
no monitor session <session> reflector-port >
Function: To configure reflector port, the no form of this command will delete the reflector port.
Parameter: <session>: Session ID, range between 1 to 4, <interface-number>: Interface number.
Command Mode: Global Mode.