Adding a new configuration, Dding a, Onfiguration – Ag Leader InSight Ver.8.0 Users Manual User Manual
Page 90
76
Press to add a new tillage configuration. An on-screen wizard will walk you through the setup process in a
step-by-step manner. New Vehicles and Implements can be created during the setup process. For detailed
information see
“Adding a New Configuration” on page
.
• Edit button
Press to edit the name of a selected configuration. The on-screen keyboard will be displayed to complete
the desired text edits.
• Remove button
Press to remove a configuration. The vehicle and implement associated with the configuration will not be
deleted.
WARNING: When deleting a configuration all regions and data logged with that configuration will be deleted!
• Configuration Settings
Press to edit the implement switch polarity. For detailed information, see
“Configuration Settings” on page
.
• Calibrate Distance
Press to launch speed sensor calibration wizard. For detailed information, see
.
• Speed Input Settings
Press to select speed input device.
• AutoSwath Settings
The AutoSwath feature automatically increases or decreases the logged width of the tillage equipment,
according to your field's boundaries and previously-tilled areas. The AutoSwath feature includes sensitivity
levels, which compensate for varying degrees of GPS performance. To change these sensitivity levels,
press the AutoSwath Settings button.
Note: You must have an unlock code to activate the AutoSwath feature. If you have been using AutoSwath
with the DirectCommand™ system, the feature is already activated and ready to use. If you have not unlocked
the AutoSwath feature yet, the code can be purchased through your local Ag Leader dealer.
A
DDING A
N
EW
C
ONFIGURATION
To add a new configuration press the Add button. The Operating Configuration Wizard appears, as
shown.
1. Select a Vehicle
Using the drop down box select the vehicle you would like to use
in this configuration. If there are no vehicles in the list press the
New button.
For help with the adding a new vehicle wizard see
.
Press Next to continue.
2. Select Implement
Using the drop down box select the implement you would like to use in this configuration. If there are no
implements in the list, press the New button.