Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 223)

209
A
PPLICATION
7. Enter Boom Section Widths from Left to Right
The display automatically divides the boom into equal length sections. Select individual sections and use
the on-screen keypad to edit boom section lengths if needed.
Press NEXT to continue.
8. Enter Vehicle Name
The display combines the Vehicle Make and Model for use as a Vehicle Name.
Use the on-screen keyboard to edit the vehicle name if desired.
Press Finish to complete Vehicle setup and return to the Operating Configuration Wizard.
9. Select Operating Mode
Select Rate Logging/Control from the drop-down list box.
Press NEXT to continue.
10. Select Controller
Press New to start the process of adding a new product control channel.
11. Select Controller or Flow Meter
Select DirectCommand from the Device drop-down list box.
Select Liquid Product Control from the Direct Type list box.
Press NEXT to continue.
12. Flow Meter Calibration Number
Enter the pulses/unit calibration number for the product flow meter.
Press NEXT to continue.
13. Suggested Controller Name
The display assigns a default name to the controller.
Use the on-screen keyboard to edit name if desired.
Press Finish to complete Controller setup and continue with the configuration process.
14. Select Container
Press New to start the process of adding the liquid product tank.
15. Enter Container Capacity and Units
Enter the container Capacity using the on-screen keypad.
Select Units used to represent the Capacity of the container.
Press NEXT to continue.
16. Enter Container Name
Use the on-screen keyboard to assign a name to the Container.
Example Names:
• SS Tank
• 1000 Gal Tank
Press Finish to complete the Container setup process.
17. Select Ground Speed Source
Select Primary and Backup speed inputs from list boxes.
Press NEXT to continue.