Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 185)

171
A
PPLICATION
S
PEED
I
NPUT
S
ETTINGS
Select a Configuration from the list and press the Speed Input
Settings button to access the related settings. These settings
are specific to that combination of Vehicle, Implement, and
Controller.
Primary And Backup Speed Inputs
By default the display uses GPS as a primary speed input
and the choice of radar, wheel, or track sensor as a backup
speed input. If radar, wheel, or track sensor is selected as the
primary speed input, the backup option will not be available.
Manual Speed Settings
If neither primary or backup speed input devices are
functioning properly, check the Use Manual Speed option and
enter the desired simulated speed.
WARNING: Using this option can result in over or under application of products. The display will behave as
if the vehicle is traveling at the manual speed until the option is deselected.
If the Primary speed input selection is changed, the display
will read an on-screen dialog indicating that a new field region
must be created at the Run Screen for the display to resume
logging data to an existing field operation.
C
ALIBRATE
D
ISTANCE
If you are not using GPS for ground speed, then after you have created a configuration you must
calibrate the ground speed input for accurate speed and area calculations. If you are using GPS, it is
recommended to calibrate distance in the event of GPS loss.
Select a Configuration from the list and press the Calibrate Distance button to calibrate the radar or
wheel speed sensor. This calibration is specific to that combination of Vehicle, Implement, and
Controller.