beautypg.com

Automatic swath control settings, For more information, see, Utomatic – Ag Leader InSight Ver.8.0 Users Manual User Manual

Page 112: Wath, Ontrol, Ettings

background image

98

A

UTOMATIC

S

WATH

C

ONTROL

S

ETTINGS

The Automatic Swath Control feature turns sections off and
on automatically based upon the following conditions:

• Entering and exiting internal and outer field boundaries.

• Entering and exiting mapped product recommendation areas.

• Entering and exiting previously applied areas within a field.

Note: The Automatic Swath Control functionality is an optional feature of both the DirectCommand and
SeedCommand Systems. An unlock code must be purchased and installed to enable this feature. Call your
local Ag Leader dealer for details and pricing.

To access the Automatic Swath Control settings, select the Configuration tab, and press the
Automatic Swath Control button to access the related settings. These settings affect the automatic
swath control operation and are specific to that combination of Vehicle, Implement, and Controller.

• Turn-On Look-Ahead
This setting determines how far ahead the display looks to turn the sections back on. This setting
compensates for delay in the product control system when the implement sections are turned on. To see
what these numbers should look like for Row Shutoff Modules, see

“Row Shutoff Look-Ahead Numbers” on

page

99

.

• Turn-Off Look-Ahead
This setting determines how far ahead the display looks to turn the sections off. This setting compensates
for delay in the product control system when the sections are turned off. To see what these numbers should
look like for Row Shutoff Modules, see

“Row Shutoff Look-Ahead Numbers” on page

99

.

• Outside Boundary Option
Select one of the two options to determine display behavior when a section exits a field boundary or
prescription mapped area.

• Coverage Option
In the Coverage Option area, you must choose between three options:

- The Minimize Skip option turns off the implement section after the entire section is fully inside your

coverage area. This prevents the possibility of skips.

- The Minimize Overlap option turns off the implement section when that section first enters your

coverage area. This prevents the possibility of overlaps.

- The User Defined option allows you to choose what percentage of the implement section is within the

coverage area before that section turns off. For example, if you choose 50%, then the section will
switch off when half of it is within your coverage area.