Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 170)

156
b. Either: Repeat the calibration or press Finish to complete the calibration.
11. Auxiliary Step: Apply Number to All Planter Drives
a. As an optional step, you can apply the seed meter calibration number to all of the planter drives.
b. Press either Yes or No and the calibration is now complete.
S
EED
T
UBE
M
ONITOR ON
R
UN
S
CREEN
The Seed Tube Monitor Module provides
population monitoring for DICKEY-john seed
tube sensors used on several different brands
of planters.
The Seed Tube Monitor bar graph consists of a number of bars
representing row units. Each bar’s row height represents that
row’s population in comparison with the target rate which you
specify with the Target numeric keypad (see bottom row of this
table).
The Planter button brings up the Seed Monitor Options window, which is discussed
further on
“Seed Tube Monitor Options” on page 157 .
The Rate Display and Spacing Display are where Instantaneous Average Rate and
Spacing are displayed either for the entire planter, or for each row, depending upon
settings in the Seed Monitor Options.
The numeric keypad under the Target portion of the Run screen allows you to
enter the target population to display on the bar graph. Each row unit will then
appear on the bar graph showing the seed rate percentage of the number you
entered in this keypad.
Note: If you enter an incorrect number in this keypad, this will cause information shown in the bar graph to
appear out of scale.