Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 151)

137
P
LANTING
3. Accept the Muxbus Detection warning
A window appears, informing you that your configuration has changed
and that it will require a muxbus detection. Once all sensors are
disconnected, press the Accept button on the Configuration Changed
window. The Muxbus Detection Process can now begin.
4. Plug in Sensors
Order of Muxbus sensor installation
Plug in each physical sensor plug into the muxbus wiring
harness on the planter, in the order the sensors will be viewed
on the display, and follow the on-screen instructions.
Install the sensors in the order they are to be viewed on the
display
Rear Row Seed sensors from left to right.
Front Row Seed sensors from left to right.
Auxiliary Sensors in the following order:
-a.Auxiliary Section Transmission Sensors, from left to right.
-b.Auxiliary Ground Speed Pickup Sensor.
-c.EdgeVac® Sensors.
-d.Pneumatic Down Pressure.
-e.Seed Scale Sensor, Air Compressor Sensor, and ASD Sensor.
When the row unit sensor is plugged in, the display will beep
once and show the status as “Calibrating”. When calibration is
complete, the display will beep again and display either “OK” or
“Slow”.
5. Detect Complete
When the Muxbus Detection process is complete, a message
displays, stating “All sensors found” as shown at left.