Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 214)

200
3. Create New Vehicle
The Vehicle Setup Wizard appears. Select Self-Propelled Sprayer from the Vehicle Type list box.
Press NEXT to continue.
4. Enter Vehicle Information
Use the on-screen keyboard to enter names for the Vehicle Make and Model.
Press NEXT to continue.
5. Enter Full Swath Width
Use the Number Pad button to enter the full swath width of the vehicle.
Press NEXT to continue.
6. Enter Number of Boom Sections
Enter the total number of boom sections.
Press NEXT to continue.
7. Enter Boom Section Widths from Left to Right
The display automatically divides the boom into equal length sections. Select individual sections and use
the on-screen keypad to edit boom section lengths if needed.
Press NEXT to continue.
8. Enter Vehicle Name
The display combines the Vehicle Make and Model for use as a Vehicle Name.
Use the on-screen keyboard to edit the vehicle name if desired. Press Finish to complete Vehicle setup
and return to the Operating Configuration Wizard.
9. Add Equipment for Multiple Product Configuration
The Add Additional Application Equipment window appears. From here, you may add additional
equipment or controllers to your configuration. Add equipment by pressing the Add button and following
the Equipment Configuration Wizard.
Note: If you choose to add additional equipment, add them in the same order as the implements are attached.
10. Select Operating Mode
Use the drop-down list to select Rate Logging / Control.
Press NEXT to continue.
11. Select Controller
Use the drop-down list to select the desired controller. If the controller you wish to use is not in the list
press New.
Press NEXT to continue.
12. Select Controller or Flow Meter
Select DirectCommand from the Device drop-down list box.
Select Liquid Product Control from the Direct Type list box.
Press NEXT to continue.