Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 198)

184
L
IQUID
D
IRECT
C
OMMAND
C
ONTROLLER
S
ETTINGS
The settings contained on this configuration window
determine liquid product control valve performance.
Controller Setup Screen
Under the Controller Tab, press Controller Settings to access
the advanced setting screens.
The picture at left shows the default settings for the liquid
product inline servo valve. Bypass servo, PWM 12-volt, PWM
Ground, Calibrated Reflow and Pump Servo Control method
are also supported by the DirectCommand system.
• Definitions for these settings can be found at “Controller Settings”
on page 268
• A table listing default values can be found at “Liquid Product
Control Valve Configuration Options” on page 273 .
Note: Minor adjustment may be required for proper performance of individual applicators.
D
IRECT
I
NJECTION
C
ONTROLLER
S
ETTINGS
The settings contained on this configuration window
determine Direct Injection product pump performance.
To view the Direct Injection Controller Settings
window, go to the Controller Tab, highlight the desired
controller, and press Controller Settings.
• Pump Calibration
- Factory Calibration: This number is found on the tag of the Digital Pump Speed Sensor. This tag
number represents pulses per 10 fluid ounces. Divide the tag number by 10 and enter this number.
Once entered, this number should not be changed.