Ag Leader InSight Strip-Till - Manual

Part No. 2002831-42 Rev. C 1
Granular Strip-Till Control Module
Quick Reference Sheet
Section 1: Configuration Procedure
The following setup procedure describes how to configure a Strip Till Module for
a multiple product application. To begin this procedure, go to the Application Setup
Configuration Tab and press the Add button.
Note: In order for you to use this configuration at the Run screen, you must also
configure a vehicle, implement, controller and product(s). For more information on how
to configure these, consult the InSight User Manual.
Strip-Till Configuration (for multiple products)
STEPS ACTION
1 Select Equipment Configuration Type
The Operating Configuration Wizard appears. Select either Single Product Application, or
Multiple Product Application. As this particular procedure describes how to configure a
Multiple Product Application, we have chosen this setting.
Note: You must have purchased a Multi-Product unlock code from Ag Leader in order to use
the Multiple Product Configuration.
2 Select Vehicle
Use the drop-down menu to choose a vehicle, or press the New button to enter a new vehicle.
Press Next to continue.
3 Add Equipment for Multiple Product Configuration.
The Add Additional Application Equipment window appears. From here, you may add
additional equipment or controllers to your configuration. Add equipment by pressing the Add
button.
Note: If you choose to add additional equipment, add them in the same order as the implements
are attached.
4 Select Implement
Select an Implement from the drop-down list menu, or press the New button to create a new
implement. Press Next to continue.
5 Select Implement Attachment Method
Use the drop-down list to select an implement attachment method. Press Next to continue.
6 Enter Full Swath Width
Use the numeric keypad to enter the full swath width of the implement. Press Next to continue.