Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 171)

157
P
LANTING
S
EED
T
UBE
M
ONITOR
O
PTIONS
Press the Planter button on the Run Screen, and the Seed
Monitor Options window appears, as shown.
• Scan
Scan Mode specifies the Rate/Spacing on a row-by-row scan on
all the planter’s row units, displayed in sequence from left to right
• Freeze
Freeze Mode specifies that the Rate/Spacing Display
continuously shows only one specified row chosen by the
operator. Use the up and down arrow buttons to specify which row
to “freeze”.
• Planter
Planter Mode is the default setting for the Rate/Spacing Display.
This mode specifies the instantaneous average population and seed spacing for the entire planter.
• Alarms button
Summons the Seed Monitor Alarms window, which shows each individual row and the alarms threshold for
that row. For more information, see
“Seed Monitor Alarms” on page 130 .
• Ignore seed alarms when row clutches turn off check box
Disables the seed alarms when the planter clutches turn off during row turns (as an example). This box is
checked by default; uncheck if desired.
• Averages
Shows the individual row number and planting rate of the row with the highest and lowest planting rate.
• Gain
Shows the population adjust value used to adjust the population if the seed tube is not sensing the actual
seed population.
- For the correct Gain setting for your operation, please refer to your planter’s operator manual.
- For corn, do not change the default Gain setting of 1.
KINZE P
OPULATION
M
ONITOR ON
R
UN
S
CREEN
The KINZE Planter Monitor Module allows a user to
manage compatible KINZE electronic seed monitoring
and variable rate drive systems.