Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 51)

37
GPS
GPS
GPS S
ETUP
GPS S
ETUP
P
AGES
The GPS settings only apply to InSight Displays connected to
one of the Ag Leader Technology approved TSIP
receiver/lightbar combinations. These settings do not apply
when using the EZ-Guide Plus or EZ-Steer products.
The settings contained on the Autopilot Tab only apply to
InSight systems connected to Trimble Autopilot systems with
a navigation controller.
.
(F
URTHER
GPS R
EFERENCES
For detailed information, see the following:
• “GPS General Setup Tab” on page 37 ,
• “GPS Serial Port Settings” on page 39 .
• “OmniSTAR Differential Setup” on page 40
• “Beacon Differential Setup” on page 41
• “External Lightbar” on page 45
• “TSIP Lightbar Settings” on page 45
• “GPS Diagnostics” on page 49.
• “Autopilot Diagnostics” on page 53.
• “Autopilot Setup” on page 54 .
• “Autopilot Guidance Options” on page 63 .
• “Autopilot Guidance Operation” on page 66 .
GPS T
ABS
GPS G
ENERAL
S
ETUP
T
AB
General GPS settings relate to choosing differential source
and NMEA messages output by the Ag Leader Technology
TSIP receiver. Details are explained below.
• For more information on other tabs which may appear on the GPS
screen next to the General tab, see
“GPS Diagnostics” on page 49 .
• For a GPS/Guidance Menu, see “GPS/Guidance Menu Tree” on
page 172 .
• GPS Receiver box
Displays the name of your GPS Receiver on the upper left-hand
side of the GPS window. In the example shown above, the GPS
receiver used is either an Ag Leader GPS 5100 or a Trimble
AgGPS 252.