Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 59)

45
G
UIDANCE
E
XTERNAL
L
IGHTBAR
TSIP L
IGHTBAR
G
ENERAL
S
ETTINGS
The display is able to control an AgGPS 21A lightbar when hooked up to an Ag Leader Add on GPS,
such as the model 3050, 3100 and 4100.
Note: For further TSIP compatibility information , see “TSIP Compatibility Reference” on page 45 .
The Power, Units, and LED Brightness frames are general
lightbar settings.
The Power frame allows you to turn the lightbar on and off through
the display since there is no power switch on the lightbar.
The Units frame allows the selection on Imperial or Metric units.
The LED Brightness frame adjusts lightbar display intensity. Use
the up and down arrow keys to adjust the brightness.
Note: For further information on TSIP Lightbar settings, see “TSIP Lightbar Settings” on page 45 .
TSIP C
OMPATIBILITY
R
EFERENCE
TSIP is an acronym for Trimble Standard Interface Protocol, which is used by receivers manufactured by
Trimble Navigation Ltd. For receivers with appropriate capabilities, TSIP can be used to control TSIP
and satellite DGPS parameters and external sensor configurations.
At present, the following TSIP receivers are supported by Ag Leader Technology products:
Ag Leader® model number
• GPS 3000
• GPS 3050
• GPS 3100
• GPS 4050
• GPS 4100
• GPS 5100
TSIP L
IGHTBAR
S
ETTINGS
The lightbar settings frame includes settings that are used to configure the lightbar for a specific
installation and set of needs.
Mounting Position
Ceiling mounting of the lightbar requires that it be inverted. This setting will allow the text to be inverted
also.
Text Display Mode
• No Text