Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 299)

285
H
ARVEST
A
DDING
A N
EW
C
OMBINE
To start the process of adding a new combine press the Add button.
1. Select Make and Model
Select the correct combine make and model from the list boxes.
Press Next to continue.
2. Edit Name
Use the keyboard button to edit the name of the combine.
Press FINISH to complete the setup process.
C
ALIBRATE
D
ISTANCE
The following procedure describes a speed sensor calibration. Before beginning, keep in mind these
two tips:
• Before beginning the speed sensor calibration, you should mark a measured distance to drive. The default
distance currently in the display (and the recommended distance) is 100 feet, or 50 meters if using metric
measurements.
• For the most accurate results, this calibration should be performed in field conditions (not on gravel or paved
roads)
To begin, go to the Combine Tab, select a Combine from the list and press the Calibrate Distance button to
begin the Speed Sensor Calibration wizard.
1. Select Speed Input
Select the sensor type to calibrate.
Press Next to continue.
2. Calibration Distance
The display defaults to 100 feet (50 meters) distance for calibration.
Press Edit Distance to change this number, if needed. This value must match the actual distance of the
course driven for calibration.