Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 106)

92
6. Select Implement Switch.
a. If you are using an implement switch, choose whether it is set up as Standard or Reversed. Otherwise press
None.
b. Press Next to continue.
7. Choose Ground Speed Source.
a. Select your ground speed source. If you will be using GPS as the primary you will need to select a
secondary source.
b. Press Next to continue.
8. Edit Configuration Name.
a. Use the keyboard button to edit the name of the configuration.
b. Press Finish to complete the setup process.
A
DDING
A N
EW
R
ATE
C
ONTROL
/ L
OGGING
C
ONFIGURATION
To add a new serial controlled planting or seeding
configuration press the Add button.
1. Select a Vehicle.
a. Using the drop down box select the vehicle you would like to use
in this configuration.
b. If there are no vehicles in the list press New.
c. Press Next to continue.
Note: For help with the adding a new vehicle wizard see “Adding A New Vehicle” on page 103 .
2. Select Implement.
a. Using the drop down box select the implement you would like to use in this configuration.
b. If there are no implements in the list press New.
c. Press Next to continue.
Note: For help with the adding a new implement wizard see “Adding A New Implement” on page 106 .
3. Select Operation Type.
a. Select the operation type. You can choose Area Logging (Site Verification) or Rate Logging/ Control. In this
case, choose Rate Logging/ Control.
b. Press Next to continue.
4. Select Controller.
a. Select the controller you will be using from the drop down list. If a new controller must be created press New.
b. Press Next to continue.
Note: See “Adding A New Controller” on page 116 for help with the wizard.