Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 216)

202
24. Enter Suggested Controller Name
Use the keyboard button to enter a controller name.
Press Finish to continue with the Operating Configuration Wizard.
25. Select Container
Use the drop-down list to select the Container that will be used with the equipment. Examples of
containers are spray solution and NH
3
tanks. Press New to add a container if required.
Press NEXT to continue.
26. Enter Container Capacity and Units
The Container Setup Wizard appears. Enter the container Capacity using the on-screen keypad.
Select Units used to represent the Capacity of the container.
Press NEXT to continue.
27. Enter Container Name and Location
Use the keypad to enter a Container Name, and use the drop-down menu to enter a Container Location.
Press Finish and you will return to the Equipment Configuration Wizard.
28. Enter Suggested Name for Configuration
Use the keyboard button to edit the suggested configuration name.
Press Finish to continue the multiproduct configuration procedure.
29. Add Equipment for Multiple Product Application
The Operating Configurating Wizard reappears. From here, you may add additional equipment or
controllers to your configuration.
• Add equipment by pressing the Add button and following the Equipment Configuration Wizard, or
• Press NEXT to continue.
Note: If you choose to add additional equipment,add them in the same order as the implements are attached.
30. Select Ground Speed Source
Select Primary and Backup speed inputs from list boxes.
Press NEXT to continue.
31. Enter Suggested Name for Configuration
A suggested name appears, which has been created from the
Vehicle, Implement and Controller names. If this name does not
fully describe the configuration, use the keyboard button to edit the
suggested configuration name.
Press Finish to complete configuration setup.
The configuration should now be displayed in the configuration list.
A
DDING A
D
IRECT
I
NJECTION
C
ONFIGURATION
To create a Direct Injection configuration, go to the Configuration Tab and press the Add button. The
Operating Configuration Wizard appears, as shown.