Kinze population monitor configuration, And kinze planter monitor users should see, Kinze – Ag Leader InSight Ver.8.0 Users Manual User Manual
Page 145: Especially the part of the, Kinze p, Opulation, Onitor, Onfiguration
131
P
LANTING
5. Calibrate the Magnetic Pickup Coil.
This step, which is performed by customers who have purchased the Magnetic Pickup Coil Speed Sensor
allows the Monitor Module to receive data from this sensor, which measures the ground speed of the
planter. See
“KINZE Magnetic Coil Speed Sensor Calibration” on page
6. EdgeVac® calibration.
This step, which is performed by customers who have purchased the EdgeVac® seed meters, allows the
display to receive accurate data from the meters. See
“KINZE EdgeVac Calibration” on page
KINZE P
OPULATION
M
ONITOR
C
ONFIGURATION
The following procedure describes the complete process of
configuring a SeedCommand KINZE Planter Monitor. To begin,
press the Setup button and go to the Configuration Tab. Here
you can select the equipment configuration type.
At the Configuration Tab, press the Add button and the
Operating Configuration Wizard appears.
Note: This procedure assumes that you have already set up a Vehicle configuration. If you have not done so,
see
“Adding A New Vehicle” on page
1. Select Vehicle
a. Select an existing Vehicle from the drop-down menu, or press Add and create a new vehicle with the
Vehicle Setup Wizard.
b. Press Next to continue.
2. Select Implement
a. Using the drop-down box, select the implement you would like to use in this configuration. If there are no
implements in the list, press New.
b. Press Next to continue.
Note: For help with the Adding a New Implement Wizard, see
“Adding A New Implement” on page
.
3. Select Planter/Seeder Type and Attachment Method
The Implement Setup Wizard appears.
a. Select the Planter setting (top drop-down menu).
b. Select an appropriate attachment Method: Rear Drawbar or Rear 3-Point Hitch (bottom drop-down menu).
c. Press Next to continue.
4. Select Implement Options
a. Select the following options, depending upon your machine’s configuration:
• Planter Monitor drop-down menu - Choose the KINZE Planter Monitor Module.
• Split Rows Enabled – Check this box to enable the display to log data from the planter’s Split Row units.
(For Split Row-enabled planters, you will need to create separate implement configurations for Split
Row and non-Split Row operations).
• Planter Section Row Shutoff – Check this box to enable the Row Shutoff and planter clutches.
b. Press Next to continue.