Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 246)

232
C
ROP
S
ENSOR
S
ETTINGS
The Settings window is where you can adjust application
rate settings specified by the OptRx Crop Sensor module.
The VI Zero and VI Minimum settings are used as a buffer to
prevent applying the wrong amount of N or applying it in
areas where doing so would be ineffective. To access the
Settings window, go to the Run Screen and press the
Settings button.
• VI Zero
The threshold below which the Crop Sensor applies a zero rate. This setting is used to prevent applying N
over bare ground or permanently damaged crops.You may enter in a value either by using the numeric
keypad, or you may enter in the current VI Reference Value by pressing the Current button.
• VI Minimum
The threshold below which the Crop Sensor applies the minimum rate. This setting is used to apply a
minimum amount of N on ground with damaged or diseased crops.
You may enter in a value either by using the numeric keypad, or you may enter in the current VI Reference
Value by pressing the Current button.
Note: The minimum rate may be adjusted at the Crop Sensor screen, which is accessed by pressing the
Algorithm button. For more information, see
“Crop Sensor Settings” on page 232 .
• Reference Strip
The name of the Reference Strip that you entered during the Configuration procedure.
• VI Reference
Value of a healthy crop biomass used in reference for calculating the proper N application rate.
• Algorithm
Press this button to access the Sensor Setup screen, where you can adjust the rate displayed on the Crop
Sensor tab’s VI Bar Graph. For more information, see
“Crop Sensor Settings” on page 232.
C
ROP
S
ENSOR
T
AB SETTINGS
Users of the OptRx Crop Sensor have a specific tab, the Crop
Sensor Tab, appear at the Run Screen, as shown.
The following settings appear on the Crop Sensor Tab of the
Run screen.