Product tab, Product tab buttons, Roduct – Ag Leader InSight Ver.8.0 Users Manual User Manual
Page 199: Uttons
185
A
PPLICATION
- Perform Calibration: Press the Perform Calibration button to begin the calibration procedure for the
Direct Injection pump. The pump will not run until this calibration has been performed. For more
information, see
“Calibrating an Injection Pump” on page
• Rate Response Warning
- Error Threshold: The user-defined percentage of actual rate error allowed before an alarm sounds.
- Error Delay: The number of seconds that the actual rate falls out of the error threshold before an alarm
sounds.
• Flow Monitor Warning
- Error Threshold: The percentage of perceived application error, based on the discharge flow sensor.
- Enable Warning: The Enable Warning check box allows you the option of displaying the Flow Monitor
Warning.
P
RODUCT
T
AB
P
RODUCT
T
AB
B
UTTONS
The display requires that products be set up prior to
performing any in-field application, planter logging, or planter
control. To set up a product, go to the Product Tab and press
Add to launch the Setup Wizard.
For an Application menu that includes information on the
Product Tab, see
“Application Menu Tree” on page
167
.
• Add button
Allows you to add a new product. A wizard will walk you through setting up the product. For more
information, see
“Adding A New Product” on page
.
• Remove button
Allows you to remove a product. The product and any regions using it will be deleted.
WARNING: When deleting a product, all regions using that product will be deleted!
• Edit Info button
Allows you to specify the manufacturer of a variety in the Product Information. For more information, see
.
• Edit Legend button
Launches a wizard that allows you to change the legend associated with the selected product. For more
information, see