Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 206)

192
6. Component Base Amount
Enter the Base Amount of the component.
Press FINISH to complete the process of adding the component.
Note: The Base Amount is the total volume of product that would be present in the 1000 gallon mix applied
at a 10 GPA rate.
7. Add Additional Components
Press Add to start setting up the second mix component.
8. Select Mix Component
Select the desired component from the list box.
Press NEXT to continue.
Note: If the desired product is not already set up, press New to set up the product.
9. Enter Component Base Amount
Enter the Base Amount of the component.
Press FINISH to complete the process of adding the component.
Note: The Base Amount is the total volume of the component that would be present in the 1,000 gallon mix
applied at a 10 GPA rate.
10. Add Product Carrier
Mix/Blend contents screen showing herbicides added to the tank mix.
No additional active ingredients are required for this tank mix, the water used as the carrier is the only
additional component.
Press Add to begin the process of adding water as a carrier for the active components.
11. Carrier Selection
Select water from the list box.
Press NEXT to continue.
Note: If the desired product is not already setup, press New to set up the product.
12. Carrier Base Amount
As displayed in step 10 of the example, 965 gallons of water are required to complete setting up this tank
mix.
Enter 965 as the base amount of water.
Press FINISH to complete the process of adding the carrier.
13. Tank Mix Component Setup Completed
The dialog box at left shows the tank mix with all components added.
Press NEXT to continue.