Adding a new calibration, Dding a, Alibration – Ag Leader InSight Ver.8.0 Users Manual User Manual
Page 311
297
H
ARVEST
A
DDING A
N
EW
C
ALIBRATION
If you notice a decreased yield accuracy, you may need to perform a new calibration. To do this, use the
following procedure.
1. Show Calibration Numbers
On the Harvest window, under the
Calibration
tab, press the
Show Cal Numbers
button.
2. Start New Calibration
When you press the
Show Cal Numbers
button, the Weight
Calibration Numbers window appears, as shown at upper
left. On the left-hand side of the Weight Calibration Numbers
window is a list of grain calibration values that range from
C1
through
C11
. These 11 C numbers determine the weight that
the display calculates from the data that it records into your regions as you harvest. These numbers
have been pre-set by Ag Leader Technology, and you should not change them unless instructed to by
Ag Leader Technical Support.
On the right-hand side of the Weight Calibration Numbers window, three more numeric values
appear:
M1
,
S1
, and
V1
. The
M1
and
S1
numbers are set specific to the combine model and are used for
calibration. Do not change these unless instructed to by Ag Leader Technical Support. The
V1
number is
the Vibration Calibration number. As with the first two numbers, do not change the
V1
(Vibration
Calibration) number unless instructed to by Ag Leader Technical Support.
To start a new calibration press the New Cal button, located on the lower right-hand side of the Weight
Calibration Numbers window. After the New Cal button is pressed, the display will apply the new
moisture and grain weight calibration from this point forward.