Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 254)

240
S
TRIP
T
ILL
C
ONTROL
S
ETTINGS
Press the Strip Till Control button, located on the left-hand side of
the Application Tab, for the Strip-Till Control window to appear, as
shown. From here, you can calibrate the Product Density and CFR
settings.
• Strip Till Settings (for two channels)
This density value (shown in pounds per cubic foot, or lb./ft.
3)
, is stored with each combination of product
and control channel. Use the keypad to edit, if needed.
Note: For proper machine performance and accuracy, you should check the Product Density daily.
• CFR 1
The amount of product that is distributed with each revolution of the metering circuit. Shown in Cubic Feet
per Revolution (ft.
3
/rev).
CAUTION: New products will have a default CFR number the first time they are used. You must either
manually enter or perform a CFR calibration routine for each product once that product is created, otherwise
misapplication will occur.
• Static CFR Calibration
Press the Static CFR Calibration button to perform an automated routine to calibrate each metering
circuit.This calibration is performed before applying in field conditions. For more information, see
“Static
CFR Calibration Procedure (Strip-Till)” on page 240 .
• In-Field CFR Calibration
Press the In-Field CFR Calibration button to perform an automated routine to adjust the calibration number
for the selected metering circuit. This calibration is performed if there is a difference between the amount
of product logged as compared to what was actually applied. For more information, see
“In-field CFR
Calibration Procedure (Strip-Till)” on page 241 .
Static CFR Calibration Procedure (Strip-Till)
The Static CFR Calibration Procedure performs an automated routine to calibrate each metering circuit.
This calibration is performed before applying in field conditions To perform the Static CFR Calibration,
press the Static CFR Calibration button in the Strip-Till Control Window.