Ag Leader Versa DirectCommand Stepper Seed Control Quick Reference Guides - Manual

1
Stepper Seed Control
Quick Reference Guide
2006003-ENG Rev A
Start of Configuration Wizard Planting
To create a configuration, make the following button presses to start the Configuration
Wizard and then follow the instructions given on the display.
Enter Settings
Press to Highlight Configuration
8360,1770,3dr
Planting
Configuration Product
The planter will plant at this simulated ground
speed, until displayed ground speed is above
this value. Planting at the minimum ground
speed will occur when any of the following
conditions are met:
a) Ground speed is less than the above setting
b) Wheel motion is detected. Requires wheel
motion sensor
c) Jump start switch is depressed. Requires
jump start switch kit
maximum RPM of the seed meter.
The number of times the hydraulic drive sprocket
turns to achieve 1 revolution of the seed meter.
Use the formula in the examples on page 2 to
calculate Gear Ratio. Carry the decimal to the
nearest 0.0001.