Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 300)

286
Press Next to continue.
3. Start Driving Course
Follow the on-screen directions.
Press Start to begin the calibration process.
Note: When the vehicle is at the starting point, the display should read 0.0. If it displays another number, press
the Reset button.
4. Course Completed
Drive vehicle over the measured course and press Stop .
Press Next to continue to final step.
Note: It is recommended that you run the distance calibration twice to confirm an accurate calibration.
5. Calibration Completed
Press Finish to complete calibration and store the calculated
value.
Note: Calibration settings can be manually adjusted if desired by pressing Enter CAL Number and making
small changes to the setting.
GPS O
FFSETS
After completing the process of setting up a Combine, you must also configure GPS Offsets. The GPS
Offsets define where machine’s rear axle is in relation to the GPS antenna. These settings are used by
mapping and AutoSwath. To configure these, go to the Combine Tab and press the GPS Offsets button.
The GPS Offsets window appears, as shown.
Antenna Offsets