Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 193)

179
A
PPLICATION
6. Enter the Implement Name
Use the keyboard button to enter a name for the implement.
Press Finish to complete the implement setup process.
Adding A Container
A container is a dry product bin or liquid tank. Containers are configured using the following steps during
the process of setting up an implement.
1. Enter Capacity
Use the Number Pad button to enter in the capacity of the
container and then use the drop-down list to select the Units
that correspond. Press NEXT to continue.
2. Name the Container
Use the Keyboard button to enter in the desired name for the container.
Select Vehicle or Implement to indicate mounting location of the product container.
Press Finish to complete the container setup process.
I
MPLEMENT
T
AB
- A
DVANCED
S
ETTINGS
S
WATH
S
ECTION
O
FFSETS
After completing the initial process of configuring an Implement, accurate values must be entered in the
Swath Section Offsets to ensure proper machine performance. Swath Section Offsets are configured as
outlined in the following steps.
1. Select swath section
Select the desired section from the boom list and press Edit
to modify the offset values.
2. Enter left or right distance from hitch point
Use the keypad to enter the distance the mid-point of the
swath section from the machine centerline. Select to the
left/to the right to indicate the direction the swath section is
located from the vehicle centerline.
Enter the distance that the swath section is located from the
hitch point.(This option will not be present on self-propelled
vehicles.)
Press Accept when done.
3. Enter distance from front hitch to rear hitch
Use the numeric keypad to enter the distance from front hitch, if present, to rear hitch point. (This option
will not be present on self-propelled vehicles.)