Diagnostic button, Iagnostic, Utton – Ag Leader InSight Ver.8.0 Users Manual User Manual
Page 66
52
The receiver’s OmniSTAR Identification number. Reference this number when contacting OmniSTAR to
purchase subscriptions.
• Reset Autoseed button
Allows you to reconverge your GPS position. This reset feature should be used if the vehicle has moved
after the GPS receiver was turned off.
Note: After you press this button, the receiver will take a certain amount of time as the reconvergence takes
place. Therefore, your GPS position will be less accurate for a time until the reconvergence is completed.
D
IAGNOSTIC
B
UTTON
By pressing the System button, you can view the System Information window, which includes the
General, Display, and CAN tabs. This window shows generalized Diagnostic information, such as
memory, display, CAN device and firmware version information. Technical support may request that you
look at this window to help in diagnosing a problem. Additional tabs, appropriate to the connected
modules, are present as needed. For information on these additional tabs, see the Application section
under
“System Diagnostic Button” on page
; and the Grain Harvest section under
. Information on LED diagnostic states can be found at
“Module LED Diagnostic States”
on page
174.
General Tab
The General Tab contains information about the external
storage card and display memory usage.
Display Tab
The Display tab shows general and diagnostic information
about the display. Information includes:
• Display temperature
• Display and CAN Bus voltage
• Firmware information
• Hardware information
• Display run time hours:minutes:seconds
• Display boot counter