Seed tube sensor configuration, Seed monitor sensor selection, Seed tube sensor configuration” on – Ag Leader InSight Ver.8.0 Users Manual User Manual
Page 143: And also
129
P
LANTING
Seed Tube Sensor Configuration
The Sensor Configuration window shows which rows are assigned
to the individual pins on the Seed Tube Monitor Module.
The numeric keypad to move the sensor to a different location, in case you need to make
configuration changes for custom planting operations.
Note: To return to the default, press the AutoConfig button.
• Status button
Enables and disables a Seed Tube sensor.
.
Note: A row with a failed sensor can be ignored until a replacement sensor is installed.
• AutoConfig button
Sends the planter settings to the Seed Tube Monitor Module.
Note: After creating a Seed Tube Monitor Module configuration, in order for it to become active you must
perform an AutoConfig procedure.
• Remove button
Removes an individual Seed Tube sensor.
The row spacing keypad is where you must enter in the row spacing that your
planter will be planting.
Seed Monitor Sensor Selection
If you specified a split-row planting configuration in the drop-
down list shown on the Seed Monitor Setup window (
Tube Monitor Module Setup” on page
),then the Selection
window will appear (as shown) after the first time that you press
the Sensor Configuration button on the Seed Monitor Setup
window. Choose between Standard Row or Split Row and
press OK.