Ag Leader InSight Ver.8.0 Users Manual User Manual
Page 227

213
A
PPLICATION
Select Equipment Configuration Type
Select either Single Product Application, or Multiple Product
Application. As this particular procedure describes how to
configure a Multiple Product Application, we have chosen this
setting.
Note: You must have purchased a Multi-Product unlock code from Ag LeaderKINZE in order to use the
Multiple Product Configuration.
1. Select Vehicle
Use the drop-down menu to choose a vehicle, or press the New button to enter a new vehicle.
Press NEXT to continue.
Note: Select an existing vehicle from the Vehicle List. If a new vehicle needs to be added, press the New
button to launch the Vehicle Wizard.
2. Add Equipment for Multiple Product Configuration
The Add Additional Application Equipment window appears. From here, you may add additional
equipment or controllers to your configuration.
• Add equipment by pressing the Add button and follow the Equipment Configuration Wizard, or
• Press NEXT to continue.
Note: If you choose to add additional equipment,add them in the same order as the implements are attached.
3. Select Implement
Select an Implement from the drop-down list menu, or press the New button to create a new implement.
Press NEXT to continue.
Note: For more information on Implement Setup, see
“Adding a New Implement” on page
4. Select Operating Mode
Use the drop-down menu to select Rate Logging/Control. Press NEXT.
5. Select Controller
Press the New button to add a controller; then press NEXT.
6. Select Controller Device and Device Type
Select DirectCommand from the Device drop-down list box.
Scroll down on the Direct Type list box and select Granular Strip-Till Control.
Press NEXT to continue.