Norac uc5 setup, Norac uc5 setup window, More information, see – Ag Leader InSight Ver.8.0 Users Manual User Manual
Page 229: Norac uc5 s, Etup, Etup window
215
A
PPLICATION
14. Enter Suggested Configuration Name
Use the keypad to enter a suggested name for your
configuration.
Press Finish when complete.
Note: A suggested name has been provided, based on your previous selections. If this name does not fully
describe the configuration, you may change it here.
NORAC UC5 S
ETUP
NORAC UC5 S
ETUP WINDOW
To view the NORAC UC5 Setup window, go to the
Implement Tab in Application setup, select the desired
sprayer from the Implement list, check the Enable
Boom Height Control check box and press the NORAC
UC5 Setup button. The NORAC UC5 setup window
appears.
NORAC UC5 Setup window
Note:
In order to view this window, the NORAC UC5 Spray Height Controller must be installed on
your sprayer and this feature must be communicating on the CAN bus.
• The drop down menu shows the devices communicating on
the NORAC UC5 CAN Bus along with the serial number of
each device. The Firmware Version and Hardware Revisions
of your NORAC UC5 devices are shown underneath.
• Sprayer Configuration
Displays the sprayer model configured during the Automatic Setup procedure
• Automatic Setup
Loads the Select Sprayer window, which starts the Automatic Setup process. For more information, see
.