Yaskawa MP940 - Manual (Page 53)

Basic System Operation
3.2.1 DIP Switch Settings
3-6
Memory Initialization
When the DIP switch is set according to the following procedure and the power is turned
ON and OFF, memory will be initialized, and the user programs and definition data will be
deleted.
Always initialize memory if you remove the battery when the Module power supply is
turned OFF.
1 2 3 4 5
Turn OFF the
MP940 power. Turn ON the DIP
switch pins for
INIT and TEST. Turn ON the
power, and check
that the RDY and
RUN indicators
flash, and then
wait for 4 to 5
seconds (Flashes
until the power is
turned OFF). Turn OFF the
power, and return
the DIP switch
pins to their orig-
inal settings,
with only the
RUN pin ON. Turn ON the
power again.
NO
1
2
3
4
5
6
←
RUN
INITIAL
TEST
FLASH
P.P
COPY
NO
1
2
3
4
5
6
←
RUN
INITIAL
TEST
FLASH
P.P
COPY