Yaskawa MP940 - Manual (Page 252)

Parameters
6.3.1 Motion Fixed Parameter Details
6-12
17 Bit 9 Override Selection (USE_OV) Set whether or not to use the over-
ride function.
0: Disabled
1: Enabled
The OWC02C: Override is used
when this parameter is set to
Enabled. The override is fixed at 100
if this parameter is disabled.
Note: The override function allows
the feed speed setting to be
modified in an application.
0
(Disabled)
10 Deceleration Limit Switch Inversion
Selection (INV_DEC) Set whether or not to invert and use
the limit switch signal
(speed limit switch) when returning
to the zero point.
0: Do not invert
1: Invert
0
(Not inverted)
11 to 12 Not used. ---
13 Positive Overtravel Selection
(OVT1-SEL) Set whether or not to use the over-
travel function in the positive direc-
tion.
0: Disabled
1: Enabled
0
(Disabled)
14 Negative Overtravel Selection
(OVT2-SEL) Set whether or not to use the over-
travel function in the negative direc-
tion.
0: Disabled
1: Enabled
0
(Disabled)
15 Not used. --- 0
18 Number of Digits
Below Decimal
Point (DECNUM) Set the number of digits to the right of the decimal point in input reference
units. The minimum reference unit is determined by this parameter and Ref-
erence Unit Selection in the Motion Controller Function Selection Flags (bit
0 to bit 3). 3
No. Name Description Default