Yaskawa MP940 - Manual (Page 197)

5.3 Connection Methods
5-25
5
5.3.5 Power Supply Connector Cable
„ Power Supply Connector (POWER)
The MP940 Module must be supplied with a 24-VDC power supply.
The connector is a screw-locking terminal block connector (BL3.5/3F-AU, manufactured by
Weidmüler).
„ 24-V Input Cable Preparing Procedure
Use a twisted-pair cable with a wire size of AWG #24 to AWG #20 (0.2 mm 2 to 0.51 mm 2 )
when connecting the 24-VDC power supply and MP940 Module power supply connector.
Prepare a cable using the following procedure.
1. Strip the wire of its covering.
Strip the wire of its covering for 6.5 mm from the head.
2. Insert the wire to a plug.
Insert the core wire deeply into the plug and tighten the screws with a 0.3 to 0.4 Nm fas-
tening torque.
Pin No.
Signal
Name
Name
3 +24 V +24-VDC input
2 GND 0 V
1 FG
POWER
+24V
GND
FG
Pin No. Signal Name Name
3 +24 V +24-VDC input
2 GND GND
1 FG FG
6.5 mm
Core wire
Covering
+
+ side (Pin No. 4)
– side (Pin No. 2)