Yaskawa MP940 - Manual (Page 363)

Troubleshooting
9.2.4 System Register Configuration
9-18
„ Interrupt Status
Table 9.10 Interrupt Status
Interrupt Module Details
∗ 1. Module
mm=01H to 05H: Reserved by system.
mm=06H: MP940/LIO is set to 06.
mm=07H: MP940 counter (PI) is set to 07 Hex.
∗ 2. Slot
ss = Slot address of interrupted Module.
MP940/LIO is slot 3, so address is 03 Hex.
MP940/counter is slot 5, so address is 05 Hex.
∗ 3. Causes of Interrupts
xxxx=01H MP940/LIO DI interrupt is always 1 channel.
MP940/counter interrupt is always 1.
Name Register No. Remarks
Interrupt count SW00698 Number of interrupts detected
Modules where interrupt occurred SW00699 Number of Modules interrupted
for 1 interrupt
Interrupt Module SW00700 Interrupt module 1
SW00701
SW00702 Reserved by system
SW00703
to
SW00798 Reserved by system
SW00799
15 8 7 0
SW00700 Module *1 Slot *2 mmss Hex
SW00701 Status *3 xxxx Hex