Yaskawa MP940 - Manual (Page 233)

5.8 System Startup
5-61
5
4. The Definition, Programs, Table Data, and C Register Folders will be displayed in the
MP940 Controller folder. This completes the logon procedure.
„ Module Definitions
Set the basic parameters for the serial, LIO, SVA, CNTR, and MLINK functions built into
the MP940.
1. Double-click Module Configuration , which opens in the folder in the tree for the
MP940 Controller Folder.
If you open the Module Configuration Window before any settings have been made, the New Message
Box will be displayed. Click the OK Button, and then perform the following operation.
2. The Main Module Configurations Window will be displayed. With the MP940, you can
only change Rack 1 and Short. You cannot change function modules allocated to slots
00 to 06.
INFO